Zanussi ZWD 1682 W - Manual (Page 7)

7
Attention!
Before selecting programme “Drain”, Spin” or “
Gentle Spin”, the selector dial has to be positioned on
Off (cancelling).
The Rinse Hold option cannot be selected for the
automatic WASHING & DRYING programme.
Programme Option buttons
Depending on the programme, different functions can
be combined. These must be selected after choosing the
desired programme and before depressing the
“Start/Pause” button.
When these buttons are pressed, the corresponding pilot
lights come on. When they are pressed again, the pilot
lights go out.
If an incorrect option is selected, the corresponding pilot
light flashes for about 2 seconds and the message Err is
displayed.
4 “Prewash” button
With this option the machine performs a prewash cycle
at 30°C max. The prewash cycle ends with a short spin
at 650 r.p.m. in programmes for Cottons and Synthetics,
and with emptying of the water for Delicate.
This option is not available with the Wool, Handwash
and the «Mini 30».
For use when washing heavily soiled laundry.
5 “Extra Rinse” button
Can be used with all programmes except the Wool,
Handwash programmes and «Mini 30». The machine
will add 2 rinses to the Cottons programmes and 1 to
the Synthetics and Delicate programmes.
This option is recommended for people who are allergic
to detergents and in areas where the water is very soft.
6 “Auto Dry” button
This button allows you to choose the required degree of
drying for cottons and synthetics:
- Extra dry (only for cottons)
- Store dry (cottons and synthetics)
- Iron dry (only for cottons)
The relevant light illuminates.
The drying time is automatically adjusted by the
machine: the laundry will be dried to the selected degree
of dryness.
7 “Drying Time” button
If you wish to carry out a timed programme instead of
an electronic programme push the button until the
drying time you want appears in the display according
to the fabrics (cotton or synthetics) you have to dry.
For COTTONS and SYNTHETICS you can select a
time from 10 minutes to 130 minutes.
At the end of the drying programme, the “Drying” pilot
light goes out and a flashing zero appears on the display.
8 “Delay Start” button
This button makes it possible to delay the starting of the
programme selected from 30 min - 60 min - 90 min, 2
hours and then by 1 hour up to a maximum of 23 hours.
The delay you have selected is shown on the display for
about 3 seconds; afterwards, the duration of the
programme reappears.
You must select this option after you have set the
programme and before you press the “Start/Pause”
button.
The time value shown on the display will decrease by
one unit every hour.
You can change the delay time at any moment,
before you press the “Start/Pause” button.
If you have already pressed the “Start/Pause” button,
and you wish to cancel the delay time, proceed as
follows:
• set the machine to PAUSE by pressing the
“Start/Pause” button;
• press the “Delay Start” button until the display shows
the symbol « 0’ ».
• press the “Start/Pause” button again.
Important!
• The door will be locked throughout the delay time.
If you need to open the door, you must first set the
machine to PAUSE by pressing the “Start/Pause”
button. After you have closed the door, press the
“Start/Pause” button again.
The “Delay Start” cannot be selected with “Drain”,
“Gentle Spin” and “Spin” programmes.
9 “Start/Pause” button
This button has two functions:
• Start: after you have selected the desired programme
and options, press this button to start the machine. The
light above the button will stop flashing and remain lit.