Yamaha ARIUS YDP-181 - Manual (Page 46)

Detailed Settings – [FUNCTION]
Owner’s Manual 46
ENGLISH
You can set various parameters for Dual mode
to optimize the settings for the songs you play,
such as adjusting the volume balance between
two voices.
Dual mode function settings are set individu-
ally for each voice combination.
1. Select the voices in Dual mode, then engage
the Function mode and select .
2. Press the [+/YES] button to engage the Dual
mode function’s sub-mode, then use the
[TEMPO/FUNCTION
▼, ▲] buttons to select
the desired sub-mode. Press the [–/NO] [+/
YES] button to assign values.
Sub-mode
F3.1: Dual Balance
Setting range: 0 – 20 (A setting of “10” produces an
equal balance between the two Dual
mode voices. Settings below “10”
increase the volume of Voice 2 in
relation to Voice 1, and settings
above “10” increase the volume of
Voice 1 in relation to Voice 2.)
Normal setting: Different for each voice combination.
You can set one voice as the main voice, and another
voice as a softer, mixed voice.
F3.2: Dual Detune
Setting range: -20 – 0 – 20 (With positive values,
the pitch of Voice 1 is raised and the
pitch of Voice 2 is lowered. With neg-
ative values, the pitch of Voice 1 is
lowered and the pitch of Voice 2 is
raised.)
Normal setting: Different for each voice combination.
Detune Voice 1 and Voice 2 for Dual mode to create a
thicker sound.
F3.3: Voice 1 Octave Shift
F3.4: Voice 2 Octave Shift
Setting range: –1, 0, 1
Normal setting: Different for each voice combination.
You can shift the pitch up and down in octave steps for
Voice 1 and Voice 2 independently. Depending on which
voices you combine in Dual mode, the combination may
sound better if one of the voices is shifted up or down an
octave.
F3.5: Voice 1 Effect Depth
F3.6: Voice 2 Effect Depth
Setting range: 0 – 20
Normal setting: Different for each voice combination.
These functions make it possible to individually set the
depth of the effect for Voices 1 and 2 for Dual mode.
(The effect depth settings cannot be changed unless the
[EFFECT] is ON. Function mode must be exited before
the [EFFECT] can be turned ON.)
• “Voice 1” and “Voice 2” are explained on page 25.
F3.7: Reset
This function resets all Dual mode functions to their
default values. Press the
[+/YES] button to reset the values.
F3. Dual Mode Functions
NOTE
If Dual mode is not engaged, will appear instead of
and you will be unable to select Dual mode functions.
In this case, you can switch to the Dual mode by selecting two
voices.
NOTE
The available setting range is wider in the lower range (± 60 cents
for A -1), and narrower in the higher range (± 5 cents for C7). (100
cents equal one semitone.)
NOTE
SHORTCUT:
You can jump directly to the Dual mode functions
by pressing
the [TEMPO/FUNCTION] button while holding the two Dual mode
voice buttons.
To exit Function mode, you still need to press the [TEMPO/FUNCTION]
button so that the TEMPO indicator lights up.