Zebra Technologies XiIII - Manual (Page 49)

Configuration
After you have installed the media and ribbon and the power-on self test
(POST) is complete, the front panel display will show “PRINTER READY.”
(If the
printer fails its POST , refer to page 81.) You may now set printer
parameters for your application using the front panel display and the five keys
directly below it.
NOTE: Printers that are operating on an IP network can be quickly
configured via ZebraNet

WebView

(optional ZebraNet
PrintServer II required). For information, refer to
ZebraNet
Networking: PrintServer II Installation and User’s Guide.
If it becomes necessary to restore the initial printer defaults, see “FEED
Key and PAUSE Key Self Test” on page 85.
NOTE: Unless otherwise noted, all parameters are listed in the order they
are displayed, starting with “DARKNESS.”
Entering the Setup Mode
To enter the programming mode, press the SETUP/EXIT key. Press either
the NEXT/SAVE key or PREVIOUS key to scroll to the parameter you
wish to set.
NOTE: You may also press
and hold the NEXT/SAVE and PREVIOUS
keys to quickly advance through the configuration parameters.
Parameters in this section are shown in the order displayed when pressing
the NEXT/SAVE key. Throughout this process, press the NEXT/SAVE
key to continue to the next parameter, or press the PREVIOUS key to return
to the previous parameter in the cycle.
An asterisk (*) in the upper left-hand corner of the display indicates that the
value displayed is different than the currently stored value.
Zebra XiIII-Series User’s Guide 43