Xerox FlowPort - Manual

Xerox Document Centre Setup Guide for FlowPort 1
C h a p t e r 1
C h a p t e r 2
Xerox Document Centre Setup
Guide for FlowPort
This document is intended for use by FlowPort System Administrators when
configuring the following Xerox Document Centres to scan to a FlowPort server:
• Document Centre 240/255/265/460/470/480/490
• Document Centre 220/230/332/340/432/420/425/432/440
There are two basic things you must do on the Document Centre:
• Designating a “repository” on the document centre. This is the IP address of
the FlowPort server.
• Setting up a default scan template.
The procedures in this guide are provided as examples only. Because of firmware
differences, the screens you see may be different, however you may use the
concepts presented here.