ZyXEL Communications 802.11g Wireless ADSL2+ 4-port VoIP IAD P-2602HWNLI - Manual (Page 55)

P-2602HWNLI User’s Guide
Chapter 2 Introducing the Web Configurator 55
Note: For security reasons, by default the ZyXEL Device automatically logs you out if
you do not use the web configurator for five minutes. If this happens, log in
again.
Figure 11 Wizard or Advanced Screen
2.1.2 The RESET Button
You can use the RESET button at the back of the device to turn the wireless LAN off or on.
You can also use it to activate OTIST in order to assign your wireless security settings to
wireless clients. If you forget your password or cannot access the web configurator, you will
need to use the RESET button to reload the factory-default configuration file. This means that
you will lose all configurations that you had previously and the password will be reset to
“1234”.
2.1.2.1 Using The Reset Button
1 Make sure the POWER light is on (not blinking).
2 Do one of the following.
To turn the wireless LAN off or on, press the RESET button for one second and release
it. The WLAN light should change from on to off or vice versa.
To activate OTIST in order to assign your wireless security settings to wireless clients,
press the RESET button for five seconds and release it. The WLAN light should flash
while the device uses OTIST to send wireless settings to OTIST clients.
To set the device back to the factory default settings, press the RESET button for ten
seconds or until the POWER light begins to blink and then release it. When the POWER
light begins to blink, the defaults have been restored and the device restarts.