Figure 210 menu 25.1.1 ip routing policy, Table 113 menu 25.1.1 ip routing policy – ZyXEL Communications Prestige 2602R Series User Manual

Page 338

Advertising
background image

Prestige 2602R Series User’s Guide

338

Chapter 36 IP Policy Routing

Figure 210 Menu 25.1.1 IP Routing Policy

The following table describes the fields in this menu.

Menu 25.1.1 - IP Routing Policy

Policy Set Name= 1
Active= No
Criteria:
IP Protocol = 0
Type of Service= Don't Care Packet length= 0
Precedence = Don't Care Len Comp= N/A
Source:
addr start= 0.0.0.0 end= N/A
port start= N/A end= N/A
Destination:
addr start= 0.0.0.0 end= N/A
port start= N/A end= N/A
Action= Matched
Gateway type = Gateway addr Gateway addr = 0.0.0.0
Type of Service= No Change Gateway node = 0
Precedence = No Change Log= No

Press ENTER to Confirm or ESC to Cancel:

Table 113 Menu 25.1.1 IP Routing Policy

FIELD

DESCRIPTION

Policy Set Name

This is the policy set name assigned in Menu 25 – IP Routing Policy Setup.

Active

Press [SPACE BAR] and then [ENTER] to select Yes to activate or No to

deactivate the policy. Inactive policies are displayed with a minus sign “-“ in SMT

menu 25.

Criteria

IP Protocol

IP layer 4 protocol, for example, UDP, TCP, ICMP, etc.

Type of Service

Prioritize incoming network traffic by choosing from Don’t Care, Normal, Min

Delay, Max Thruput, Min Cost or Max Reliable.

Precedence

Precedence value of the incoming packet. Press [SPACE BAR] and then

[ENTER] to select a value from 0 to 7 or Don’t Care.

Packet Length

Type the length of incoming packets (in bytes). The operators in the Len Comp

(next field) apply to packets of this length.

Len Comp

Press [SPACE BAR] and then [ENTER] to choose from Equal, Not Equal,

Less, Greater, Less or Equal or Greater or Equal.

Source:

addr start / end

Source IP address range from start to end.

port start / end

Source port number range from start to end; applicable only for TCP/UDP.

Destination:

addr start / end

Destination IP address range from start to end.

port start / end

Destination port number range from start to end; applicable only for TCP/UDP.

Action

Specifies whether action should be taken on criteria Matched or Not Matched.

Advertising