Zanussi ZWX 1505 W - Manual (Page 6)

1 “On/Off” button
Press this button to switch the washing machine on.
Press the ON/OFF button again to switch the machine
off.
2 MAINS-ON light
This light is connected to the ON/OFF button. It lights
up when you press the button, and goes out when you
press it again.
3 FABRICS button
Press this button repeatedly to select the programme on
the basis of the type of laundry to be washed. The light
relevant to the selected programme will light up. The
washing machine will propose a temperature and
automatically select the maximum spin value provided
for the programme you have chosen. You can change
these values by operating buttons 4 and 5.
4 “Temp.” button
Press this button repeatedly to increase or decrease the
temperature, if you want your laundry to be washed at a
temperature different from the one proposed by the
washing machine. The relevant light will light up.
Maximum temperatures are 95°C for cotton, 60°C for
synthetic fabrics, 40°C for delicate fabrics and wool.
6
The Control Panel
1 2 3 4 5 6 7 8 9
1600
900
700
500
Delicates
60°C
50°C
95°C
40°C
Extra
Quick
Prewash
30°C
Wool
On/Off
Cottons
Synthetics
40° AA
Skip
Start/
Pause Rinse Hold
Reset
Temp. Spin
ZWX 1605 W
Prewash
Wash
Rinse
Rinse Hold
Spin
Drain
Filter
End
5 “Spin” button
Press this button repeatedly to change the spin speed, if
you want your laundry to be spun at a speed different
from the one proposed by the washing machine. The
relevant light will light up.
Maximum speeds are:
• for cotton: 1600 rpm (ZWX 1605) or 1500 rpm
(ZWX 1505);
• for synthetic fabrics and wool: 900 rpm; for
• for delicate fabrics: 700 rpm.
“Rinse Hold” position: when you choose this option,
the machine will not drain the water of the last rinse, so
as not to crease the laundry.
At the end of the cycle, the light of the “Start/Pause”
button goes out, the “End” and “Rinse Hold” lights
illuminate to indicate that the water must be drained.
To complete the cycle, first press “Skip/Reset” button
and then choose one of the following options:
• Drain only:
- Press FABRICS button in order to select the desired
programme and press 3 times “Skip/Reset” button
until the “Drain” light illuminates. Then depress
“Start/Pause” button.
IMPORTANT!
By pressing the TEMPERATURE and SPIN SPEED
buttons simultaneously for about 3 secondes, the
acoustic signal is deactivated at the end of the cycle,
when selecting the programmes and in case of an
incorrect option selection .
By pressing these 2 buttons again the acoustic signal
is reactivated.