XM Satellite Radio XMH10 User Manual
Page 14
14
NOTE:
Do not cut the antenna cable and attempt to splice it
or attach alternative connectors or cable. The cable
and connectors used in your XMH10 Home Kit are
specially chosen and attached at the factory to
ensure that they will work with XM®‘s unique
frequency band. If an antenna extension is required,
use the Terk by Audiovox XM-EXT50. This is an XM®
approved 50 foot amplified extension cable available
at your local consumer electronics retailer. Failure to
do so could damage the unit.
5. Apply power to the Xpress XM® Receiver as outlined in the
associated User Guide and obtain an audio output. If no audio
is heard, move the antenna to different positions on the
surface until an audio output is heard. This is the desired
antenna position and should be marked with masking tape or
by another nons-cratch method.
6. After determining the optimum position, turnoff Xpress power,
disconnect the power adapter from the wall outlet receptacle
and disconnect the antenna cable.
7. Plan the routing of the antenna cable to the cradle. Make sure
you avoid any obstructions that could crimp, kink or twist the
cable; use protective grommets wherever rough openings are
encountered.