Yard-Man YM155 - Manual (Page 7)

7
ASSEMBLY INSTRUCTIONS
3. Plug the charger into the wall outlet and wind any
excess wire onto the cord wrap on the charging
station (Fig. 3).
Wall Outlet
Charging Station
Screws
Wall
Stud
Cord Wrap
Charger
Fig. 3
INSTALL AND ADJUST THE D-HANDLE
1. Push the D-handle down onto the shaft housing and
push it on the boom (Fig. 1). The squared bolt hole in
the handle is to the right.
MOUNTING THE CHARGING STATION
NOTE: Mount the charging unit and allow the unit to
charge for at least 36 hours prior to first use.
This unit may stay on the charging station continuously
without overcharging. Place the charging station where
the unit is intended to be stored. This should be a cool,
dry and well ventilated place, where the unit can be
locked-up and out of the reach of children.
The unit should be stored and charged in a location
where the temperature is between 50˚F (10˚C) and 100˚F
(38˚C).
1. Locate a place for the charging station near a wall
outlet and high enough to keep the unit off the floor.
2. Locate the wall stud and mount the charging station
to the wall using the three (3) screws provided
(Fig 3). Make sure that the screws enter the wall stud
to provide a secure mount.
Charging
Indicator Light
2. Insert the shoulder bolt into the squared hole in the
handle and push through. On the left side of the
handle, place the washer on the bolt, then screw the
wing nut onto the bolt. Do not tighten until you make
the handle adjustment.
3. Rotate the D-handle to place the grip above the top
of the shaft housing. Place it a minimum of 6 inches
(15.24 cm) from the end of the housing.
4. While holding the unit in the operating position
(Fig. 2), position the D-handle to the location that
provides you the best grip.
5. Tighten the wing nut until the D-handle is secure.
To prevent injury or
damage to the unit,
the charging station must be mounted
securely to the wall.
CAUTION:
Fig. 2
Fig. 1