Yamaha DSP-AZ2 - Manual (Page 26)

24
Item
1A CENTER SP
1B MAIN SP
1C REAR L/R SP
1D REAR CT SP
1E LFE/BASS OUT
1F FRONT EFCT SP
1G MAIN LEVEL
1H SP B SET
Description
Selects the output mode according to whether or not a center speaker is
being used and its performance.
Selects the output mode according to the performance of the main
speakers.
Selects the output mode according to whether or not rear L/R speakers
are being used and their performance.
Selects the output mode according to whether or not a rear center
speaker is being used and its performance.
Selects the speaker according to use for LFE signal output and low bass
signal.
Selects the output mode according to whether or not front effect
speakers are being used.
Selects the main speaker level.
Select the location of the main speakers to be connected to the
SPEAKERS B terminals.
Control value (default
setting indicated in bold)
LRG/SML/NONE
LARGE/SMALL
LRG/SML/NONE
LRG/SML/NONE
SWFR/MAIN/BOTH
YES/NONE
Normal/–10 dB
MAIN / ZONE B
SPEAKER MODE SETTINGS
This unit has 8 SPEAKER SET items on the SET MENU that you must set according to the number of speakers in your
configuration and their size. The following table summarizes these SPEAKER SET items, and shows the initial settings
as well as other possible settings.
If the initial settings shown in the following table are not appropriate for your speaker configuration, change settings
following the steps described in “1 SPEAKER SET” from pages 56 to 59.
Summary of SPEAKER SET Items 1A through 1H
0104DSPAZ2_23-27_EN(GB) 02.8.22, 0:15 PM 24