ZyXEL Communications PRESTIGE 128MH - Manual (Page 167)

Prestige 128MH PSTN Router/Hub
System Maintenance 13-11
The following Table 13-3 describes the diagnostic tests available in Menu 24.4 for your Prestige
and the connections.
Table 13-3. System Maintenance Menu Diagnostic
Fields Description
Drop WAN Port This command drops the call on a WAN port. Selecting this option brings you to
the Select WAN Port field to specify the port.
Reset WAN Port This command resets the specified WAN port. Selecting this option brings you to
the Select WAN Port field to specify the port.
Manual Call This option allows you to manually place a call to a remote node. The
Prestige will show you the trace of what is happening during the call setup
and PPP negotiation.
Redirect to WAN Port This command redirects the keyboard to the WAN port. Anything you type will
be sent to the WAN device and the device’s response will be shown on your
screen. Selecting
this option brings you to the Select WAN Port field to specify
the port
Internet Setup Test This test checks to see if your Internet access configuration is correct. When
this option is chosen, your Prestige will call the ISP and perform the PPP
negotiations. If everything is working properly, you will see an appropriate
response. Otherwise, note the error message and take the appropriate
troubleshooting steps.
Ping Host This diagnostic sends an ICMP echo packet to the remote host and shows
you the round-trip time when the Prestige gets a response. This is to test if
the host is reachable via TCP/IP.
Reboot System This option reboots the system.
Command Mode This option allows you to enter the command mode. This mode allows you to
diagnose and test your Prestige using a specified set of commands.