X10 Wireless Technology SC1200 - Manual (Page 17)

32 33
TAMPER
ZONE 9
PROBLEM
ZONE 9
OPEN
ZONE 9
Using the system
If there’s a problem
If a door or window is open and you try to arm the system the display looks as below.
Where ZONE 9 is the door or window that’s open.
If a Door/Window Sensor or Motion Detector has not reported in within the last 4 hours
and you try to arm the system the display shows:
If a Door/Window Sensor has been tampered with, e.g. the cover is open, and you try to
arm the system the display shows:
For all the above situations, pressing the Clear (Bypass) button bypasses the problem
zone and lets you arm the system. After pressing Bypass the next problem zone is
displayed, (if there is more than one).
You can’t arm the system while there’s a problem zone unless you fi x the problem, or
bypass the zone. If you try to arm the system while there’s a problem with one or more
zone you will hear a repetitive “trouble alarm” to alert you that you need to bypass or fi x
the problem zone(s).
Note also, if the Console itself has been tampered with, i.e. the door to the upper right of
the display is open, the problem must be fi xed (close the door) before you can arm the
system. Note if the system is armed and this door is tampered with, the alarm trips.
If you bypass a zone and then arm the system, that zone stays bypassed until you disarm
the system.
DISARMED
****
12:00 am
ENTER PIN
12:00 am
Using the system
Arming the system
Press ARM HOME on the Console to arm all Door/Window Sensors instantly. Motion
Detectors will not trip the system when it is armed in the ARM HOME mode.
Press ARM AWAY to arm all Door/Window Sensors and Motion Detectors. This arms the
system after a set delay. The delay will be what you specifi ed as the EXIT DELAY on page
27 (1 minute default). If you arm the system in the AWAY mode you will also have an entry
delay when you enter your home before the alarm trips, to give you time to disarm it. This
delay will be what you specifi ed for your ENTRY DELAY on page 27 (30 second default).
Pressing ARM on the Keychain remote always arms in the AWAY mode, but arms
instantly.
Disarming the system
Pressing DISARM on the Keychain remote disarms the system instantly. The zone that
was violated is shown in the display. To remove this press Arm and Disarm again.
To disarm from the Console: Enter your 4 digit PIN (Personal Identifi cation Number) this
will be 0000 unless you changed it (see page 24).
Entering the PIN clears the top line and shows * for each number entered.
If the unit was armed, (in either ARMED HOME or ARMED AWAY modes) it will disarm
when the PIN is entered, and return to the time display, with DISARMED in the top line.