Yamaha HTR-5250 - Manual (Page 44)

40
Adjusting Method
Adjustments should be performed with the remote control
while watching the information on the display.
1 Set the selector dial to the
AMP/TUN (or DSP/TUN)
position.
2 Press TIME/LEVEL repeatedly to select the
item you want to adjust.
Each time you press TIME/LEVEL, the selected item
changes and appears on the display as shown below.
y
You can also select the item by pressing d. (Pressing u changes
the selection in the reverse order.)
Note
• Depending on the setting of the SET MENU, you may not be able
to select all these items.
DELAY TIME AND SPEAKER OUTPUT LEVELS
1
2
3
3 Press i or j to adjust the
delay time or speaker
output levels.
4 Repeat steps 2 and 3 to adjust the settings of
any other item.
Memory back-up
The memory back-up circuit prevents the stored data
from being lost when this unit is set in the standby mode.
If, however, the power cord is disconnected from the AC
power outlet or the power is cut for more than one week,
the latest values for the delay time and the center/rear/
subwoofer output levels that were set will automatically
return to the preset values. If so, adjust the delay time
and output levels again.
Delay time
Center speaker output level
Right rear speaker output level
Left rear speaker output level
Subwoofer output level
D E L A Y
C E N T E R
R S U R .
L S U R .
S W F R
0108V596(UCA)35-41_EN 3/1/0, 1:19 PM 40