Xantech HD44CC5 - Manual (Page 12)

08905071B - 12 -
COMMON PROBLEMS AND TROUBLESHOOTING
Poor video quality (picture is washed out): Several manufacturers of cable and satellite box may
have higher than normal DC offset on the video signals. When connected to an HD44C, HD44CC5,
and HDTXSG01, this may result in a washed out picture. To remedy this problem, a DC blocker
should be used between the source component and the HD44C, HD44CC5, and HDTXSG01.
Picture appears to be blooming: A blooming picture is usually caused by a video signal that is too
high. One reason for this problem is the HDRXSG01 was not synchronized to the HD44CC5. To
correct this, be sure the CAT5 cables is connected between the HD44CC5 and HDRXSG01. Remove
power from both devices. Simultaneously apply power to both units. This will synchronize the correct
signal strength.
Xantech Corporation
13100 Telfair Avenue, 2/F
Sylmar, CA 91342
www.xantech.com
Phone: (818) 362-0353, Fax: (818) 362-9506
Installation Instructions, HD44CC5, HD44C © 2007 Xantech Corporation
This document is copyright protected. No part of this manual may be copied or reproduced in any form without prior
written consent from Xantech Corporation.
Xantech Corporation shall not be liable for operational, technical, or editorial errors/omissions made in this document.
Document Number 08905071B