Zenoah EXZ2600DL - Manual (Page 22)

GB-22
EXZ2600DL
WARNING
This product is equipped with extremely sharp blades,
and when used improperly these blades can be ex-
tremely dangerous and improper handling can cause
accidents, which may in turn lead to serious injury
or death. For this reason, you should always be care-
ful to follow the following instructions when using
your trimmer.
• Never hold the trimmer in a way in which the blades
are pointed towards someone else.
• Never allow the blades to come into proximity with
your body while the engine of the trimmer is in opera-
tion.
• Always be sure to turn off the engine before chang-
ing the angle of the blades, removing branches which
have become stuck in the blades, or at any other time
when coming into close proximity with the blades.
• Always wear work gloves made of leather or some
other sturdy material when using the trimmer.
• Always place the blade cover provided with the trim-
mer over the blades when not in use.
• Falling branches may fall onto the face or into the
eyes, resulting in injuries, scratches, and cuts, and
for this reason you should always be sure to wear
a helmet and face protector when using your trim-
mer.
IMPORTANT
The thickness of branches, which may be cut using this
trimmer, is limited to up to approximately 3/16" (5 mm).
Never try to cut branches thicker than this, as doing so
may result in damage to the trimmer.
8. Operation
(LRT-EX only)
Adjusting the angle of the cutting blades
(1) Clamp lever (2) Trimming mechanism
1. Stop the engine.
2. Turn the bolt located on the top of the trimming mecha-
nism counter-clockwise to loosen it.
3. Adjust the angle of the blades to the desired angle,
and then fix the bolt firmly back into place.
Tighten
Loosen