Zanussi ZT 1082 - Manual (Page 9)

9
If the door has to be opened from left to right,
invert the position of the plates (7), the magnet (4)
and the plate (5) (Fig. B and E). Mount the
countermagnet (6) and the hinges (1) as previously
described.
Important: the plastic screw (8) should never be
loosened (Fig. B and E).
Recommendations regarding the
construction and fitting of a base
when the installation requires an
integrated appliance to be raised
Where the appliance has been raised by mounting
onto a wooden base provided by the installer. The
material used to construct the base should have a
non slip surface, be water repellent and if possible
be one solid piece.
If it is not possible to use one solid piece, due to
the additional height required, ensure that any
additional strips of timber are glued and screwed to
the underside of the base (see Fig. F).
Drill four fixing holes see Fig. G
600-605 mm
50 mm
Front edge
Top view
95 mm
490 mm
G
600-605 mm
Front view
5 mm Hardwood strip
Additional pieces of
timber should run
from front to back
100 mm
40 mm
F
4
6
5
1
2
3
7
8
E
P0983
Position the base into the recess with its front edge
as far forward as the adjoining plinth line will allow.
The reason for placing the base in this position
is to allow a small strip of beading to be fitted
in front of the appliance feet.
Fix the base firmly to the floor using four
appropriate countersunk screws (see Fig. H).
With the appliance installed adjust all four feet
ensuring the machine is stable, and a clearance of
approximately 5 mm is left between the top of the
machine and the underside of the worktop.
A final check for stability should be carried out with
the machine on spin with a load, this will identify
the need for any further fine adjustment to the feet.
A strip of beading approximately 605 mm W, x 5
mm H, x 25 mm D must be screwed down into the
base directly in front of the machine’s feet, this will
provide additional security.
If required an additional door magnet, part number
1242394-00/3 and disc, part number 1242393-00/5
are available from spare parts.
600-605
5 X 25 X 605
Hardwood strip
5 mm x 25 mm
H
490