Zebra Technologies P310i - Manual (Page 4)

DECLARATIONS OF CONFORMITY
This equipment is being tested for compliance with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses ans can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference’s by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
The user may find the following booklet, prepared by the Federal
Communications Commission, helpful:
How to identify and resolve Radio/TV Interference Problems. This booklet is
available from the U.S. Government printing Office, Washington, D.C.
20402, Stock No. 004-000-00345-4.
Use of a shielded cable is required to comply within Class B limits of Part 15
of FCC Rules.
Pursuant to Part 15.21 of the FCC Rules, any changes or modifications to
this equipment not expressly approved by Zebra may cause, harmful
interference and void the FCC authorization to operate this equipment.
INDUSTRY CANADA NOTICE
This device complies with Industry Canada ICS-003 class A requirements.
III
Card
Printer
Solutions
General information
Getting started
Operation
Cleaning
Specifications
Appendix A
Appendix B
Troubleshooting
Printing a card
Appendix C
P310 i Plastic Card printer
European Council Directive
73/23/EEC modified
by 93/68/EEC
EMC Directive
EN 500082-1,1992
Immunity to
Electromagnetic
Disturbances
Compliance to Standards
89/336/EEC
modified by
92/31/EEC and
93/68/EEC
RF Emissions
control
Low voltage
Directive
EMC Directive
EN 60950
EN 55022-B
Product safety
Model: P310 i conforms to the following specification:
FCC Part 15, Subpart A, Section 15.107(a) and Section
15.109(a) Class B digital device-Testing in process