Xerox Phaser 3435 - Manual (Page 21)

2.6
<System setup>
PostScript
This menu provides you with the Print PS Error menu item.
EPSON
This menu sets the EPSON emulation configuration.
Item Explanation
Print PS
Error
You can select whether or not your printer prints an
error list when a PS error occurs.
• Select On to print PS 3 emulation errors. If an error
occurs, the job stops processing, the error message
prints, and the printer flushes the job.
• If this menu is set to Off, the job is flushed without an
indication of the error.
Item Explanation
Font
You can select the standard font that will be used in
EPSON emulation.
Character
Set
This item allows you to select a character set of the
desired language.
Character
Tab.
This item selects the character set.
Pitch
You can determine the font size by setting the number
of characters that will print in one horizontal inch of
type.
LPI
You can set the number of lines printed in one vertical
inch.
Auto
Wrap
This item determines whether or not the printer
automatically performs line feed when the data
overflows the printable area of the print material.
Values: On, Off
Values: SANSERIF, ROMAN
Values: USA, FRANCE, GERMANY, UK,
DENMARK1, SWEDEN, ITALY, SPAIN1, JAPAN,
NORWAY, DENMARK2, SPAIN2, LATIN
Values: ITALIC, PC437US, PC850
Values: 10, 12, 17.14, 20
Values: 6, 8
Values: Off, On
Network menu
This menu lets you configure the network interface installed in your
printer. You can reset the network interface and print a configuration
page.
Item Explanation
TCP/IP
This item allows you to manually set the TCP/IP
addresses or receive the addresses from the
network.
• DHCP: The DHCP server assigns the IP address
to you automatically.
• BOOTP: The BOOTP server assigns the IP
address to you automatically.
• Static: You can enter IP address, subnet mask,
and gateway manually.
EtherTalk
This item lets you select whether or not you use the
EtherTalk protocol.
• Off: You can disable the EtherTalk protocol.
• On: You can enable the EtherTalk protocol.
Ethernet
Speed
This item allows you to select the ethernet speed.
Clear
Setting This item performs a simple reset and restores the
factory default settings for the network
configuration. This setting will only take effect after
you have reset the printer.
Network
Info. This item prints a page showing the network
parameters you set.
802.1x
This item is for connecting with an authentication
server. If you need to connect this product to an
authentication server, set this item On.
CentreWare
IS
This item lets you select whether or not you use the
embeded web server called CentreWare IS. If you
turn this item Off, you cannot connect to the
printer’s embeded web server.
Values: DHCP, BOOTP, Static
Values: Off, On
Values: Auto, 10M Half, 10M Full, 100M Half,
100M Full
Values: Off, On
Values: Off, On