Zanussi ZDC 5370 W - Manual (Page 16)

16
Adjusting the level of conductivity
Water contains, a variable quantity of limestone and
mineral salts of which quantities vary according to
geographical locations thus varying its conductivity
values.
Relevant variations of the conductivity of the water
compared to those prefixed by the factory could
slightly influence the residual humidity of the
laundry at the end of the cycle.
Your dryer allows you to regulate the sensitivity of
the drying sensor based on conductivity values of the
water by using the following procedure.
Procedure:
Turn the programme selector dial to switch on the
appliance
In selection mode press simultaneously the buttons 3
and 6 until «
C0 » appears on the digits.
Adjusting the level of
conductivity:
Press the button 5 sequentially: the level of
conductivity is indicated by the lighting of the
horizontal hyphens.
6 3 2 4 5
Start/
Pause
No
Buzzer Delay
Start
Drying
Cooling
End
Full Tank
Quick
Dry
Low
Temperature
ZDC 5370W
6 3 1 2 4 5
COTTON Extra dry
Ready to wear
Iron dry
Slightly damp
Store dry
Wring dry
Store dry Extra dry Iron dry
EXTRA PROGRAMMES
Start/ Pause No Buzzer Door Delay Start
Drying
Cooling
End
Full Tank
RESET/ OFF
Quick Dry Low Temperature
60 min
Cooling
SYNTHETIC
Easy iron
90 min
30 min
Baby dry
ZDC 5370W
1.25
Normally, the appliance is factory-set to the
highest level; however, certain models may be
configured differently.
Memorizing the new
setting:
Simultaneously press down the buttons 3 and 6 until
the previous drying cycle time appears again on the
display and the buzzer sounds.
Display Conductivity degree
Approximative value
(µS/cm)
C C 0 0 Low < 300
C C 0 0 Medium 300 - 600
C C 0 0 High > 600
125981230.qxp 2005-09-03 11:58 Page 16