Zenoah BK4310FL - Manual (Page 14)

14
6. OPERATION
■ STARTING THE ENGINE
1. Pour the fuel and fasten the fuel cap. (OP1)
(1) Cap
(2) Fuel tank
• Make sure that the cap is firmly shut and there is no
fuel leak.
• Wipe out the spilled fuel.
2. Open the fuel cock. (OP2)
3. Move the choke lever to the closed position. (OP2)
(1) Fuel cock
(2) Close
(3) Open
(4) Choke lever
(5) Close
(6) Open
When restarting immediately after stopping the engine,
move the choke lever to the open position.
4. Set the throttle lever to the starting position. (OP3)
(1) Idling
(2) Starting (1/3–1/2 open)
(3) Full throttle
When restarting immediately after stopping the engine,
move the throttle lever to the idling position.
5. While holding the unit firmly, pull out the starter rope
quickly. (OP4)
6. After the engine has started, open the choke
gradually.
7. Allow the engine to run for 2 to 3 minutes to warm up.
NOTE
NOTE
IMPORTANT
(1)
(2)
OP1
OP2
OP3
OP4