Yamaha DSP-AZ1 - Manual (Page 45)

E-
43
B
ASIC OPERA
TIONS
English
5 5 Adjust the volume to the desired output level.
If desired, use BASS, TREBLE, BASS EXTENSION and
BALANCE. These controls are only effective for sound from
the main speakers.
Cautions
• If the component connected to the VCR 1 OUT, VCR 2
OUT, VCR 3/DVR OUT, CD-R OUT and MD/TAPE OUT
jacks is turned off, the reproduced sound may be distorted or
the volume may be lowered for the characteristics of A/V
component. In this case, turn on the component.
• While PROCESSOR DIRECT is tuned on, tone controls
(BASS and TREBLE) or/and BASS EXTENSION cannot
be activated.
6 6 Select a DSP program if desired.
Use PROGRAM q/w (DSP program buttons on the remote
control) to select a DSP program. See pages 86 to 94 for details
about the DSP program.
BASIC PLAYBACK
VOLUME
VOLUME
BASS TREBLE
BASS
EXTENSION
L R
BALANCE
PROGRAM
1
HALL 1
2
HALL 2
3
CHURCH
4
5 6 7 8
JAZZ CLUB
0 CHP/INDEX + 10 + 100
ROCK
CONCERT
ENTER–
TAINMENT
CONCERT
VIDEO 1
CONCERT
VIDEO 2
9 10 11 12
TV
THEATER EX/ES
MOVIE
THEATER 1
MOVIE
THEATER 2
/DTS
SUR.
■ BGV (Back Ground Video) function
The BGV (Back Ground Video) function allows you to combine a
video signal from a video source with a sound signal from an audio
source. (For example, you can listen to classical music while you
are watching a video.)
Using the remote control, select a source from the video group, then
select a source from the audio group. Use the input selector buttons
on the remote control to make your selections.
Note
• The BGV function does not work if you select the sources using
INPUT SELECTOR on the front panel.
■ To mute the sound
Press MUTE on the remote control. To resume the audio output,
press MUTE again.
Notes
• You can also cancel mute to press any operation buttons such as
VOLUME +/–.
• While the mute function is on, “MUTE ON” appears on the front
panel display.
• When this unit enters the standby mode, the mute function will be
cancelled.
■ When you have finished using this unit
Press STANDBY/ON (STANDBY on the remote control) to set
this unit in the standby mode.
V–AUX TUNER PHONO
CABLE SAT MD/TAPE CD–R CD
D–TV/LD VCR 1 VCR 2 VCR3/DVR DVD
MUTE
STANDBY
STANDBY
/ON