Xerox 4635 - Manual (Page 26)

HIP (HOST INTERFACE PROCESSOR) MESSAGES
HP1140 Cannot abort job(s): xxxx (, yyyy, etc.)
The HIP ABORT jobs command was entered. The system is
unable to process the command because job(s) entered were
not received by printer.
Action 1. Verify that the job numbers were entered correctly.
2. Reenter the command.
HP1150 Cannot start job(s): xxxx
The HIP START jobs command was entered, but the system is
unable to process the jobs indicated because they are either not
in the pending or receive state, or they have already been
started.
Action 1. Verify that the job numbers were entered correctly.
2. Reenter the command.
HP1160 Logging already enabled
You have entered the HIP LOG [START] command. The system is
informing you that the log is already enabled.
Action None.
HP1170 Log file allocation less than specified
The system is informing you that there is insufficient disk space in
the file system for the number of log entries specified in the
LOG ENTRIES command. The system allocates the largest
possible number of entries available for the disk space.
Action None.
HP1171 New log file created
A new log file has been created.
Action None.
HP1172 Log file empty, nothing to print.
You have entered the HIP SHOW LOG [PRN] command and
there are no entries in the log file.
Action None.
HP1180 No echo servers on list
There are no echo servers on list.
Action None.
HP1181 Echo test started. Results available in nnn seconds
The echo test has been started.
Action None.
4-4 XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE