Yamaha HTR-6180 - Manual (Page 112)

108
En
Using multi-zone configuration
Operating Zone 2
Rotate the R
INPUT selector to select the
desired input source while the ZONE2 indicator
is flashing in the front panel display.
• Select “TUNER” as the input source to use the TUNER
features in Zone 2. For details about the TUNER
operations, see “FM/AM tuning” on page 53.
• Select “XM” as the input source to use the XM
Satellite Radio features in Zone 2. For details about the
XM Satellite Radio operations, see “XM Satellite
Radio tuning” on page 59.
• Select “SIRIUS” as the input source to use the SIRIUS
Satellite Radio features in Zone 2. For details about the
SIRIUS Satellite Radio operations, see “SIRIUS
Satellite Radio™ tuning” on page 64.
• Select “V-AUX” as the input source to use iPod
features or Bluetooth features in Zone 2. For details
about the iPod operations, see “Using iPod™” on
page 70 or “Using Bluetooth™ components” on
page 72.
Set Zone 2 to the standby mode
Press H
ZONE 2 ON/OFF to set Zone 2 to the
standby mode.
y
Press LSYSTEM OFF to set the main zone and Zone 2 to the
standby mode simultaneously.
■ Setting the remote control to the Zone 2
mode
The remote control is originally set to the main mode to
control the main zone. To control Zone 2 with the remote
control, you must first set the remote control to the Zone 2
mode.
1
Press 2
CODE SET using a ballpoint pen or
a similar object.
The BTRANSMIT indicator on the remote control
flashes twice.
2
Press the numeric buttons (6) to enter the
code number “9992”.
■ Controlling Zone 2 with the remote
control
Turning on Zone 2
Press and hold D
POWER or CSTANDBY and
then press 4 to set the remote control to the
Zone 2 mode.
• Press DPOWER when the main zone is turned on.
• Press CSTANDBY when the main zone is turned off.
The BTRANSMIT indicator on the remote control lights
up while the remote control is set to the Zone 2 mode.
• When the remote control is set to the Zone 2 mode,
DPOWER, CSTANDBY, EVOLUME +/–, GMUTE, and
the input selector buttons (
4 ) are set to control Zone 2.
However, the rest of the remote control buttons remain in the
main mode.
• The remote control automatically exits from the Zone 2 mode in
the following cases:
– when you do not make any operations within 10 seconds after
the remote control is set to the Zone 2 mode.
– when you press a remote control button other than
DPOWER, CSTANDBY, EVOLUME +/–, GMUTE, the
ASCENE buttons and the input selector buttons (
4 ).
Activating the Zone 2 operation mode
Press D
POWER to turn on Zone 2.
Operating Zone 2
Press one of the input selector buttons (4) to
select the desired input source of Zone 2.
Setting Zone 2 to the standby mode
Press C
STANDBY to set Zone 2 to the standby
mode.
Operate the following operations after activating the Zone 2
operation mode.
TRANSMIT
STANDBY POWER POWER POWER
AV TV
TRANSMIT CODE SET
Flashes
Notes
TRANSMIT
4 3 2 1
8 7
0 9
6 5
SUR. DECODE ENHANCER PROG
PARAMETER STRAIGHT PURE DIRECT
AUDIO SEL MULTI CH IN
Flashes
POWER
STANDBY
PHONO
TRANSMIT
Lights up
While holding
down
or