Yamaha GX-3 - Manual (Page 31)

E-25
English
•
When recording important selections, be sure to make a
preliminary test to ensure that the desired source material
is being properly recorded with good sound quality.
•
The automatic recording level control circuit automatically
controls the level of the input signal used for recording.
•
Adjusting the VOLUME control and using the built-in
graphic equalizer and sound field processor have no
effect on the recorded sound.
•
For the tape deck, the deck which can be used for
recording is the DECK B only. When recording, be sure to
load a tape into the DECK B cassette compartment.
Recording from the built-in tuner
1
Press the TUNER input selector button.
2
Tune to the desired station. (Refer to the “TUNING
OPERATION” on page 15 and 16.)
3
Load a tape into the DECK B cassette compartment.
4
When recording with the Dolby NR system, press the
Dolby B NR button so that the indicator over the button
lights up. If not, set it off.
*
For details on the Dolby noise reduction, refer to the
“Dolby NR (Noise Reduction) system” on page 20.
5
Select the reverse mode “ ” to record on only one
side, or “ ” for continuous recording on both sides by
pressing the reverse MODE selector button.
6
Press the REC/PAUSE button.
*
The indicator over the button will light up and the play
direction indicators will flash.
7
Press the play button to record on side A, or the play
button to record on side B.
* For continuous recording on both sides, begin on side
A. Recording stops automatically at the end of side B.
To stop recording temporarily
1 1
Press the REC/PAUSE button.
2 2
To resume recording, press the play button whose
indicator is flashing.
To stop recording
Press the stop button.
OTHER RECORDINGS
1
6, 1 1 5 4
7, 2 2 3
1
6, 1 1
7, 2 2
CD TUNER TAPE POWER
1 2 3
1 2 3
FM/AM
4 5 6
4 5 6
7 8 9
7 8 9
0
0 CD/TUNER
+10
DISPLAY
SLEEP
AUX PLAY/PAUSE
TIME REPEAT STOP
TAPE EDIT PROG RANDOM
MUSIC
LOCATION
USER
VOLUME
TAPE
A B
REC/
PAUSE
DECK