Maintenance – Zenoah EDG2300 User Manual
Page 14
14
• Before cleaning, inspecting or repairing
your unit, make sure that engine has
stopped and is cool. Disconnect the
spark plug terminal to avoid accidental
engine starts.
■ DAILY INSPECTION
• Remove grass or dust, from the entire
body.
• Check that all nuts and screws are
securely tightened, and no parts are
missing.
• Check for leakage of fuel.
WARNING
■ INSPECTION EVERY 25 HOURS
• Remove the air cleaner element from the
carburetor air intake cover and wash in
warm, soapy water. Dry completely before
installing.
Maintenance
■ MAINTENANCE CHART
every every every
25
50
100
system/compornent
procedure
before hours hours hours
note
use
after
after
after
fuel leaks, fuel spillage
wipe out
✔
fuel tank, air filter, fuel filter
inspect/clean
✔
✔
replace, if necessary
see
■ADJUSTING
replace carburetor
idle adjusting screw
✔
IDLING SPEED (p.13)
if necessary
clean and readjust
GAP: .025in(0.6~0.7mm)
spark plug
✔
plug gap
replace, if necessary
cylinder fins, intake air cooling vent
clean
✔
muffler, spark arrester, cylinder exhaust port
clean
✔
throttle lever, ignition switch
check operation
✔
screws/nuts/bolts
tighten/replace
✔
✔
not adjusting screws
Maintenance, replacement, or repair of the emission control device and systems may be
performed by any non-road engine repair establishment or individual.
Cleaner element
Cleaner cover