Zanussi ZDC46130S - Manual (Page 19)

19
It is dangerous to alter the specifica-
tions or attempt to modify this prod-
uct in any way.
Care must be taken to ensure that
the appliance does not stand on the
electrical supply cable.
Any electrical work required to install
this appliance should be carried out
by a qualified electrician or compe-
tent person.
Important:
The appliance must not bulit-in.
Unpacking
Slide out the polythene bag with the
polystyrene stuffing before using the appliance
Pull off adhesive strips from inside machine on
top of drum.
Should the appliance be moved, it must be
transported vertically.
The appliance must not be installed behind a
lockable door, a sliding door a door with a
hinge on the opposite side to that of the
appliance.
Positioning
It is recommended that, for your convenience, the
machine is positioned close to your washing
machine.
The tumble dryer must be installed in a clean
place, where dirt does not build up.
Air must be able to circulate freely all round the
appliance. Do not obstruct the front ventilation
grille or the air intake grilles at the back of the
machine.
To keep vibration and noise to a minimum when
the dryer is in use, it should be placed on a firm,
level surface.
Once in its permanent operating position, check that
the dryer is absolutely level with the aid of a spirit level.
If it is not, raise or lower the feet until it is.
The feet must never be removed. Do not restrict the
floor clearance through deeppile carpets, strips of
wood or similar. This might cause heat build-up which
would interfere with the operation of the appliance.
Important:
The hot air emitted by the tumble dryer can
reach temperatures of up to 60°C. The
appliance must therefore not be installed on
floors which are not resistant to high
temperatures.
When operating the tumble dryer, the room
temperature must not be lower than +5°C and higher
than +35°C, as it may affect the performance of the
appliance.
Installation
125986546.qxp 2008-01-23 10:33 Page 19