Philips LFF6020W - Manual (Page 31)

LFF6020
- 27 -
6 - Network features
Connect your WLAN adaptor
Your machine belongs to a new generation of terminals
that you can incorporate into a WLAN network using a
WLAN USB key.
1 Plug your WLAN USB key into the USB port of your
machine.
Configure your network
Creating or rejoining a network
Before attempting to use a WLAN adaptor on your
machine, you must enter the parameters that will allow a
WLAN network to recognise your machine.
On your machine you will find simple instructions
that guide you step by step through the set-up of your
network. Just follow them!
281 - SETUP / WLAN / CONFIG. ASS.
1 Type in , select the menu SETUP using the keys
or and confirm with OK.
2 Select WLAN using the keys or and confirm
with OK.
3 Select CONFIG. ASS. using the keys or and
confirm with OK.
The machine searches for existing networks.
4 Select your existing network, or select NEW
NETWORK to create it, using the keys or and
confirm with OK.
5 SSID appears on the screen, enter the name of
your network using the numerical keypad, pressing
the keys one after the other until you obtain the
name you want (32 characters maximum) and
confirm with OK.
6 AD-HOC MODE or INFRA. MODE appear on the
screen. Go back to the beginning of the chapter
and make your choice.
Select one of these modes and confirm with OK.
- If you choose AD-HOC mode, the sub-menu
CHANNEL appears, enter a figure between 1
and 13 (1 to 11 for the US) and confirm with OK.
7 Select your encryption method, OFF, WEP or
WPA, and confirm with OK:
- If you choose WEP, enter the WEP key that you
are using on your network.
- If you choose WPA, enter the WPA or WPA2
key that you are using on your network.
Note
You can be sure of perfect
communication if you use an
approved adaptor in conjunction with
your PC.
All of the latest printer drivers for the
approved adaptor may be found on
our website together with further
information:
www.sagem-communications.com.
Important
Your machine’s network radio
adaptor transmits data using the
radio protocol IEEE 802.11g; it can
also be incorporated into an existing
IEEE 802.11b network.
When connecting to your machine,
only use the approved adaptor.
Other transmitting or receiving
adaptors may damage your device.
Irrespective of whether you use your
machine in an infrastructure or ad-
hoc network, you must set up certain
network and security parameters
(for example, the Service-Set-ID
(SSID) and the encryption key).
These must match the network’s
specifications.
Note
We recommend that the settings of
your WLAN network should only be
changed by a person with a good
knowledge of the configuration of your
computer.
Note
If you choose an existing network,
steps 5 and 6 (and possibly 7) are
carried out automatically.
Important
Please note that in ad-hoc mode,
the WPA/WPA2 encryption method
is not available.
Note
The WEP key number may be
configured in the menu: 29 -
SETUP / TECHNICALS / WEP KEYS
NBR.