3Com 3C389 - Manual (Page 35)

DOS Client 16 for Novell NetWare 4.01 and Above Installation 3-11
OS/2 NDIS 2 device driver using LAPS installation is
complete when the following conditions exist:
■
The device driver files load successfully and there are
no error messages.
■
You are able to log on and communicate with the
network.
If you experience problems, go to Chapter 5,
“Troubleshooting.”
DOS Client 16 for Novell NetWare 4.01 and
Above Installation
1 Insert the Novell 4.01 Diskette into the floppy disk
drive.
2 Type:
install [Enter]
Follow the steps on the panels as they appear.
3 Record the client directory name in order to do a
client installation.
The default directory name is C:\NWCLIENT.
4 At the Insert the driver disk window, insert
TokenDisk diskette #2 and type:
a:\novell\dos [Enter]
5 Select Other drivers.
6 Choose 3Com TokenLink Velocity PC Card.
7 At the Settings for 3Com TokenLink Velocity PC Card
window, press [Esc].
8 At step 5, press [Enter] to finish installing NetWare.
9 Press Enter to exit the installation tool.
10 Configure the 3C389 PC Card.
11 If LANAID is not already installed, install it as
described in Chapter 4 in the section “Installing
LANAID.”