3Com IWILL DK8X - Manual (Page 30)

DK8X Motherboard
EPS12V P OWER C ONNECTORS
Find the proper orientation of the connectors and push down firmly to make sure that the
pins are aligned (the connector will only insert properly when properly aligned). The
8-pin connector is a dedicated power connector to supply power for the CPUs. For Wake
on LAN support, the 5-volt Stand-by lead (+5VSB) from the ATX power supply must
supply at least 2A.
IMPORTANT
It is recommended that you use an ATX Power Supply that complies with the Intel ATX
2.03 specification.
________________________________________________________________________
2-16 Hardware Installation
EPS12V PSU Only