Regarding the indicator lamps – 3M X70 User Manual

Page 43

Advertising
background image

43

T

T

roubleshooting (continued)

roubleshooting (continued)

Regarding The Indicator Lamps

Lighting and flashing of the standby/on indicator, the lamp indicator, and the temp
indicator have the meanings as described in the table below. Please respond in
accordance with the instructions within the table. If the same indication is displayed after
the treatment, or if an indication other than the following is displayed, please contact your
dealer or service company.

• When the interior portion has become overheated, for safety purposes, the

power source is automatically turned off, and the indicator lamps may also be turned off.
In such a case, press the “

” (OFF) side of the main power switch, and wait at least 45

minutes. After the projector has sufficiently cooled down, please make confirmation of
the attachment state of the lamp and lamp door, and then turn the power on again.

NOTE

standby/on

indicator

lamp

indicator

temp

indicator

Description

Lighting

in

Orange

Turned

off

Turned

off

The projector is in a standby state.

Please refer to the section “Power On/Off”.

Blinking

in

Green

Turned

off

Turned

off

The projector is warming up.

Please wait.

Lighting

in

Green

Turned

off

Turned

off

The projector is in an on state.

Ordinary operations may be performed.

Blinking

in

Orange

Turned

off

Turned

off

The projector is cooling down.

Please wait.

Blinking

in

Red

(discre-

tionary)

(discre-

tionary)

The projector is cooling down. A certain error has
been detected.

Please wait until the STANDBY/ON indicator finishes blink,
and then perform the proper response measure using the
item descriptions below as reference.

Lighting

in

Red

Lighting

in

Red

Turned

off

The lamp does not light, and there is a possibility
that interior portion has become heated.

Please turn the power off, and allow the unit to cool down at
least 20 minutes. After the projector has sufficiently cooled
down, please make confirmation of the following items, and
then turn the power on again.
• Is there blockage of the air passage aperture?
• Is the air filter dirty?
• Does the peripheral temperature exceed 35°C?
If the same indication is displayed after the treatment,
please change the lamp by referring to the section “Lamp”.

(This table is continued to the following page.)

Advertising
This manual is related to the following products: