888 Digital High Definition Digital Set Top Box HD4000 - Manual (Page 12)

10
First time installation
Note: Be sure to turn on the main power at the rear of your receiver before using the
receiver.
After all the connections have been made properly, switch on your TV. Make sure
the receiver is connected to the mains and press Power to switch the receiver on. If
you are using the receiver for the first time or restored to factory default, a First
Time Installation menu will be displayed to guide you through the initial setup to
set the time zone, the daylight saving, the TV screen type and scan channels.
Use the remote controller to finish the setup.
When finished the scanning, all active channels found will be stored automatically.
The last found channel will be viewed. (In case you want to stop the scanning,
press the EXIT key to exit. The channels already found will be stored).
Now you are ready to watch digital terrestrial TV channels and radio broadcasts.
In case you skip the First Time Installation screen, you can press MENU key to
bring up the main menu (please refer to page 14 for operation guidance)