GE GEH-6510 - Manual (Page 2)

GE PMCS App Note 31 Page 2 of 5
http://genet.edc.ge.com/pmsys/Technote/note31.htm 6/10/99
17. RAS Server TCP/IP Configuration dialog: Select radio button: This computer
only. Select radio button: Use static address pool. Enter into Begin field:
1.2.3.4. Enter into End field: 1.2.3.14. Click: OK. Note: Any valid address
range can be entered.
18. Remote Access Setup dialog: Click: Continue.
19. Setup Message dialog: Message advising you to install MS Loopback
Adapter: Click: OK.
20. Network Settings dialog: Click: Add Adapter.
21. Add Network Adapter dialog: Select from dropdown list: MS Loopback
Adapter. Click: Continue.
22. MS Loopback Adapter Card Setup dialog: Take the Frame Type default,
Click: OK.
23. Windows NT Setup Dialog: Enter: path. Click: Continue.
24. Network Settings dialog: Click: OK.
25. TCP/IP Configuration dialog: Enter IP Address: 1.2.3.15. Enter Subnet
Mask: 255.0.0.0. Click: OK. Note: Any valid address can be entered.
26. Domain/Workgroup Settings dialog: Take default, Click: OK. Note: You do
not need to take the default.
27. Windows NT Workstation Networking Setup dialog: Click: Restart
Computer.
28. Access: Main/Control Panel/Services.
29. Services dialog: Double-click from list: Remote Access Server.
30. Service dialog: Select Startup Type radio button: Automatic. Click: OK.
31. Services dialog: Click: Close.
32. Shutdown and Restart computer.
33. Access: Remote Access Service/Remote Access Admin. Note: You should see
your computer name listed under Server with the Condition as Running. If
you do not see your computer name listed, close Remote Access Admin, wait
one minute, and try again. The RAS Service may not have had enough time
to startup. If you still cannot see it, try typing the computer name in the
Server/Start Remote Access Service/Server dialog box. If this does not start
RAS, see the Administrator Tools/Event Viewer for more information.
34. Remote Access Admin dialog: Click: Users. Click: Permissions.
35. Remote Access Permissions dialog: Click: The user that the view node will
login as. Click check box: Grant dialin permission to user. Click: OK.
RAS - Host Configuration with a Network Adapter Installed:
1. Access: Main/Control Panel/Network. Click: Add Software.
2. Add Network Software dialog: Select from dropdown list: Remote Access
Service. Click: Continue.
3. Windows NT Setup dialog: Insert your original NT installation disks or CD,
enter path, and click Continue.
4. If the correct modem is not displayed, you must Add it now.
5. Your modem should now be displayed and highlighted.
6. Remote Access Setup dialog: Click: Configure.
7. Configure Port dialog: Select radio button: Receive calls only. Click: OK.
8. Remote Access Setup dialog: With your modem displayed and highlighted,
Click: Network.
9. Network Configuration dialog: Select Server Settings check boxes: NetBEUI
and TCP/IP. Select radio button: Require Microsoft encrypted
authentication. Click: OK.
10. RAS Server NetBEUI Configuration dialog: Select radio button: This