3M Headset Intercom System C1060 - Manual (Page 11)

Model C1060 Controls and Indicators

3M 2001 February
5
The headset controls are shown below.
1
2
3
4
5
6
7
8
9
10
11
13
12
14
15
Figure 6. Headset Controls
Press the switch once to turn on the headset, and press it again (when the
headset is on) to turn off the headset
Press the volume up control to increase the volume in the headset earpiece.
Press the volume down control to decrease the volume.
When either volume control is pressed, the headset emits a short tone to indicate
the new volume level. There are multiple volume levels from minimum to
maximum.
If the headset volume is at its maximum level, a low, continuous tone sounds
when the volume up control is pressed. A low, continuous tone also occurs
when the volume reaches minimum level and the volume down control is
pressed.
When the headset is turned on, headset volume automatically returns to the mid-
range level. Note that even when set to its lowest level, headset volume is not
turned completely off.
Press and hold the T1 (Talk Lane 1) switch to talk to the customer at the menu
sign in lane 1. Release the switch to listen.
1 ON / OFF Switch
Headset
2 Volume UP
Control
3 Volume DOWN
Control
4 T1 (Talk Lane 1)
Switch