3M SCP717 - Manual (Page 9)

4 © 3M 2008. All Rights Reserved.
Usage Notice 3M™ Super Close Projection System
WARNING
• Lamp replacement caution. Before removing the screws, discon-
nect the power cable. Hot surface inside. Allow 1 hour to cool
before replacing the lamp. Handle with care. Risk of explosion.
See Owner's Manual.
• Unplug the projector from the electrical outlet and allow the lamp
to cool for 60 minutes before replacing the lamp.
• Wait at least 30 minutes for the lamp assembly to cool before
replacing.
• Always handle the fragile lamp module with care.
• In the event of a lamp rupture, call a 3M authorized service pro-
vider for repair. Ruptured lamp is not user serviceable.
• Ventilate the area where the lamp rupture occurred. The lamp
operates at high pressure and temperature.
• Replace the lamp module when the lamp replacement message
appears.
• Never replace the lamp module with a previously used lamp
module.
• Hg: Lamp contains mercury. Don't throw in trash. Dispose ac-
cording to local, state, or federal laws. See www.lamprecycle.org
or call 1-800-328-1371.
• Wash your hands thoroughly if contact with ruptured lamp debris
has taken place.
• Ventilate the area where the lamp rupture occurs. The lamp oper-
ates at high temperature.