Answering and ending calls, Adjusting the volume, Last number redial – Plantronics Discovery 610 User Manual
Page 68: Using the mute, Moving out of range, Fitting your headset
*Neutral Position
ansWEring anD
EnDing calls
1.
To answer a call, briefly press the call
control button or the volume/mute button.
2.
To end a call, briefly press the call
control button.
aDjUsting tHE
VolUmE
To increase the listening volume of the headset,
press the upper end (+) of the volume/mute button.
To decrease the listening volume, press
the lower end (-).
WARNING:
Do not use headphones/headsets
at high volumes for an extended period of
time. Doing so can cause hearing loss. Always
listen at moderate levels. See www.plantronics.
com/healthandsafety for more information on
headsets and hearing.
last nUmBEr rEDial
To activate last number redial, double click the
call control button. You will hear a high tone for
each key press.
NOTE:
Last number redial must be supported
by your device or cellular provider.
Using tHE mUtE
To turn the mute on whilst on a call, press
both sides of the volume/mute button
simultaneously until you hear a beep.
To turn the mute off, press both buttons
again.
moVing oUt of rangE
As the headset is moved away from the mobile
phone or Bluetooth device, the following could
occur:
•
Audio quality will degrade.
•
A beep will be heard in the headset.
•
Only the power off function will operate.
After 30 seconds, the headset will make one
attempt to reconnect to the phone or device.
fitting YoUr HEaDsEt
The headset comes with three soft gel
ear tips and an optional ear stabilizer.
The medium sized ear tip is installed for
wearing on the right ear.
1.
Twist the ear tip to the right for left
ear wearing.
2.
Place the headset into your ear with the
elongated side of the ear tip pointing up
and forward.
If the fit is not comfortable, either too
tight or too loose, remove the ear tip from
the headset by turning the ear tip to the
neutral* position and pulling the ear tip
away from the headset.
1.
Select the ear tip size that fits most
comfortably in your ear.
2.
Hold the ear tip with the elongated
edge pointing down and push the
ear tip post into the opening on the
headset.
3.
Twist the ear tip to the left for right
ear wearing or to the right for left
ear wearing.
4.
Place the headset into your ear with
the elongated side pointing up and
forward.