Vitek VT-1685 - Manual (Page 5)

5
ENGLISH
5
Installing the Glass Tray
1. Install the rotating roller base (4) into the opening lo-
cated on the bottom of the cooking chamber.
2. Carefully install the glass tray (5) onto the roller base
(4). Never install the glass tray upside-down.
• Do not inhibit the rotation of the glass tray while the
oven is in operation.
• Always use the glass tray and roller base when cook-
ing food.
• Food and cooking dishes should always only be pla-
ced on the glass tray.
• The glass tray can rotate clockwise or counter-cloc-
kwise. This is normal.
• Replace the glass tray immediately if any cracking or
splitting is detected.
POWER LEVEL KNOB
Setting
Output
Power
Cooking examples
Low (низкая) 17%
Softening ice cream,
keeping a meal warm
Defrost (размо-
розка)
40%
Defrosting food
products
M.Low (ниже
средней)
48% Soften chocolate or
glazes, melt butter or
soft cheeses, baking
candy
Med (средняя) 66%
M.High (выше
средней)
85%
Preparing steamed
meat or chicken
High (высокая)
100%
Preparing fruits,
vegetables, soup, fish.
Reheating previously
prepared meals
SETTING THE COOK TIME (7)
Rotate the knob clockwise to set the cooking time from
one to thirty minutes.
STARTING THE OVEN
• For beginning to cook, make sure that the specifica-
tions of the electrical system matches those indicat-
ed on the device’s housing.
• Select the desired power level by setting the POWER
knob (8) to the needed position.
• Place the food to be cooked into the cooking cham-
ber and close the door.
• Set the desired cooking time by rotating the TIME
knob (7) clockwise; the oven will turn on and begin-
ning cooking the food.
NOTE: if you need to set the cooking time for 2 minut-
es or less, first rotate the TIME knob clockwise past the
number 2 and then back again to the desired setting.
WARNING: ALWAYS RETURN THE TIME SETTING KNOB
(7) TO THE ZERO POSITION to turn off the oven, if you
need to remove the food before the cooking time has fin-
ished or if you are not using the oven. Open the door in
order to stop the oven during the cooking process; cook-
ing will resume when the door is closed again.
CARE AND CLEANING
Disconnect the power cord from the outlet before
cleaning.
• Do not allow moisture to come into contact with the
control panel. Clean it with a soft, lightly dampened
paper towel.
• Keep the oven’s cooking chamber clean. If pieces
of food or sprayed liquids remain on the walls of the
oven, remove them with a damp paper towel.
• A mild cleanser may be used if the cooking chamber
is very dirty.
• Do not use abrasive cleansers or wire brushes to
clean the oven, inside or out. Do not allow water of
cleaning liquids to enter the openings on the top of
the oven designed for ventilating air and steam.
• Do not use ammonia-based cleaning solutions.
• Outer surface should be cleaned with a damp cloth.
• The oven door should always be clean. Do not allow
crumbs of food to gather between the door and face
panel of the oven as this can prevent the door from
closing normally.
• Clean dust and dirt regularly from the ventilation
openings on the microwave housing, through which
air enters the oven for cooling purposes.
• Remove and clean the glass tray and its base regu-
larly; wipe the bottom of the cooking chamber.
• Wash the glass tray and drive base in a neutral clean-
ing solution. These parts are dishwasher safe.
• Do not submerse the glass tray in cold water while it
is hot: the glass tray could break due to the sudden
temperature change.
• To remove unpleasant odors from the cooking cham-
ber, place a glass of water with a little lemon juice and
boil it for several minutes. Thoroughly wipe the walls
of the cooking chamber with a soft paper towel.
TECHNICAL INFORMATION
Power requirements:
220-240 V ~ 50 Hz
Nominal output power: 800 Wt
Oven volume: 20 l
Glass tray (diameter): 245 mm
The manufacturer reserves the right to change the
device's characteristics without prior notice.
Service life - no less than 5 years.
GUARANTEE
Details regarding guarantee conditions can be obtained
from the dealer from whom the appliance was pur-
chased. The bill of sale or receipt must be produced
when making any claim under the terms of this guar-
antee.
This product conforms to the EMC-
Requirements as laid down by the
Council Directive 89/336/EEC and to the
Low Voltage Regulation (73/23 EEC)
Vt-1685.indd 5 Vt-1685.indd 5 13.08.2009 14:50:00 13.08.2009 14:50:00