Binatone MRE-8804 - Manual (Page 7)

7
ENGLISH
Note: metal parts of the filter holder (12) and the metal
filter (16) can be very hot. Hold the filter with the
filter clamp (11), when cleaning it.
Cappuccino Preparation
Cappuccino is espresso coffee with thick milk froth. To prepare
cappuccino, you should first prepare espresso. Therefore, use the
amount of water required for preparation of espresso plus a suf-
ficient amount of water for generation of steam for cappuccino.
1. To froth milk for cappuccino, you should first remove water
from the cappuccino tube (6). Place a suitable container un-
der the cappuccino tube (6). Turn the operating mode switch
(3) to the “steam” position and wait until water stops running
from the tube. Turn the operating mode switch (3) to the “O”
position.
2. Fill the container with milk by a third. The milk and the con-
tainer must be cold. Place the container with the milk under the
cappuccino tube (6) and immerse its rubber tip into the milk.
Turn the operating mode switch (3) to the “steam” position.
Carefully move the milk container with circular motions. The tip
of the cappuccino tube (6) must not touch the bottom of the
milk container as it may prevent the steam release.
3. After enough froth has been generated, turn the operating
mode switch (3) to the “O” position.
4. Using a spoon, put the milk froth produced into the cup where
espresso is contained.
CARE AND CLEANING
1. Turn the operating mode switch (3) to the
“0” position and unplug the appliance from the
outlet. Make sure that the coffee maker has
cooled down.
2. Remove the filter holder (12) from the cof-
fee maker and then remove the coffee grounds
from the filter (16), while holding it with the
filter clamp (11). Wash the filter holder (12) and the filter
(16) with water.
3. Wipe the coffee maker body (4) with soft damp cloth. Do not
use solvents or abrasive cleansers when cleaning the appli-
ance.
4. Remove and wash the drip tray (9), the grate (8), the rubber
tip of the cappuccino tube (6), the water reservoir (14) and
the lid (13) with warm water and soap. Rinse and dry thor-
oughly.
5. For additional cleaning of the disk in the point of attachment of
the filter holder (12): first, disconnect the disk by undoing the
nut, then clean the disk, using a toothpick or a needle. You can
also place the disk into a vinegar/white salt solution for a few
hours.