Festool CS 50 st accessories PRECISIO - Manual (Page 7)

7
Sliding table ST
The sliding table consists of a guide rail
(4.2) which is mounted to the left side of the
CS 50 EB/CMS GE/ MFT/3-VL and a carriage (4.1)
which slides on the guide rail.
For transport, the slide can be fi xed to the guide
rail using the rotary knob (3a.5).
Stop WRA 500 can be attached to the curved
groove on the carriage at the same time as the
CS 50 EB/CMS GE.
Fitting CS 50/ CMS-GE
– Attach one bracket at each of the two external
recesses (1.1) on the base chassis using the peg
(1.2).
Caution: the protruding points (1.3) on each of
the brackets must point outwards.
– Slide the brackets into the groove (1.6) until the
outer edge (with protruding points) lines up with
the join (1.4) on the base frame and the snap-
on clips lock onto the protruding points in the
groove.
– Lower the guide rails into position at an angle,
locating both plastic brackets (2.1) in the groove
(2.2) on the saw table.
– Swivel the guide rails downwards so that the
pegs (1.5) on the brackets engage in the holes
(2.3) on the guide rails.
Note: the guide rail has three drilled holes and
can therefore be secured in two positions (pro-
truding point to the rear or front).
– Secure the guide rails using the two rotary knobs
(3a.3).
– Slide the carriage with the four rollers (3a.4)
onto the guide rails from the side as shown in
Fig. 3a.
– Secure the end stops (3a.1) at both ends of the
groove (3a.2).
Fitting MFT/3-VL
– Insert the guide rail into the groove (3b.1) on the
extension at an angle from above with the two
plastic brackets (2.1).
– Lower the guide rail so that the rotary knobs on
the guide rail (3b.3) engage in the holes (3b.2)
on the extension.
Note: the guide rail has three drilled holes and
can therefore be secured in two positions (pro-
truding point to the rear or front).
– Secure the guide rails using the two rotary knobs
(3b.3).
– Slide the carriage with the four rollers (3a.4)
onto the guide rails from the side as shown in
Fig. 3a.
– Secure the end stops (3a.1) at both ends of the
groove (3a.2).
Height adjustment
– Unscrew both rotary knobs (3a.3).
– Turn both Allen screws (4.3) until the sliding
fence is approx. 1 mm above the saw table.
– Tighten the rotary knobs (3a.3).
Angle adjustment
– Angle adjustment
– Open both screws (5.1).
– Turn the screw (5.2) until the contact surface of
the slide is parallel to the table surface of the
bench circular saw. Check the parallelism by
placing a straight ruler over the slide and the
table of the bench circular saw.
– Close both screws (5.1).