Festool PD 20 - Manual (Page 14)

14
Q U A D R I L L
GB
8.3 Angle attachment [5]
The angle attachment (partly as an accessory) al-
lows the user to drill and fasten at right angles to
the machine.
 Prior to initial use: apply some multi-purpose
grease to the drill spindle and the gearbox neck.
8.4 Depth stop [6]
The depth stop (partly as an accessory) allows the
user to insert screws to a predefined depth. You can
set the dimension by which the screw head pro-
trudes above or is recessed below the surface of the
workpiece.
Depth setting
Turn the housing [6-1] to set the
desired fastening depth. Each
detent position changes the fas-
tening depth by 0.1 mm.
Sleeve A/B must be removed before a screw can be
unscrewed.
8.5 Tool holder in the drill spindle [7]
Bits can be inserted directly into the hexagon sock-
et holder of the drill spindle.
9 Working with the machine
Please observe all mentioned safety infor-
mations and the following rules when work-
ing:
– Only use tools designed for the specified maxi-
mum speed.
– Only sharp tools ensure efficient drilling and pre-
vent machine overload.
– Always use faultless, sharpened HSS drill bits
(HSS: High Speed Steel) when drilling into metal.
– Do not cause the machine to seize through over-
loading.
– Always switch off the machine before placing on
the nut/screw.
– Caution: when inserting long screws, there is a
risk the bit may slip from the screw head and
cause injury.
– Machine vice: clamp the workpiece securely in a
machine vice, for example, before drilling to pre-
vent the workpiece from turning and causing ac-
cidents.
9.1 Bit depot [1-1]
Magnetic, for storing bits and bit holders.
9.2 Belt clip [1-9]
The belt clip (right/left) allows the user to attach
the machine briefly to work clothing.
9.3 Lighting
ON: Press the LED light switch[1-3].
OFF: Press the LED light switch [1-3] again.
 The light remains switched on for approx. 20 s
after the machine is disconnected from the
mains power.
9.4 Warning signals
Acoustic warning signal
An acoustic warning signal sounds and the ma-
chine switches off in the following operating states:
Visual warning signal
A visual warning signal is issued and the machine
switches off in the following operating states:
10 Service and maintenance
Customer service and repair only
through manufacturer or service
workshops: Please find the nearest
address at:
www.festool.com/Service
Use only original Festool spare parts!
Order No. at:
www.festool.com/Service
To ensure constant air circulation, al-
ways keep the cooling air openings in
the motor housing clean and free of blockages.
Machine overloaded.
LED [1-3]
Red - flashing
Machine has overheated.
Press the Speed set button [1-
4]
to switch the machine to
recovery mode. Do not place
under load! The machine
reverts to normal operating
mode once the machine has
cooled, if the Speed set button
or on/off switch are pressed or
the machine is placed under
load.
WARNING
Risk of injury, electric shock
 Always disconnect the mains plug from the
socket before performing maintenance work on
the machine!
 All maintenance and repair work which requires
the motor housing to be opened must only be
carried out by an authorised service workshop.
peep peep peep
EKAT
1
2 3 5
4