Festool Ti 15 - Manual (Page 16)

16
TI 15 GB
 Turn the clamping ring as far as the stop to se-
cure the adapter.
Angle attachment DD-AS [7]
Drilling and screwing at right angle to machine
(partly as an accessory).
Eccentric attachment DD-ES [8]
Screwdriving near edges with bits according to ISO
1173 (partly as accessory).
9 Working with the machine
9.1 Operating modes
Depending on the tool holder / adapter selected,
the machine is operated as follows:
9.2 On/Off switch [1-2]
Press = ON, release = OFF
 Depending on the pressure applied to the ON/
OFF switch the speed/impact rate can be con-
trolled continuously.
The LED bulb [1-4] lights up when the ON/OFF
switch is pressed [1-2].
9.3 Bit depot [1-1]
Magnetic, for storing bits and bit holders.
9.4 Belt clip [1-9]
For short-term fixing of the device to work attire:
can be moved to the right or left or can also be de-
tached from the battery pack.
9.5 Acoustic warning signals
Acoustic warning signals sound and the machine
switches off in the following operating states:
10 Service and maintenance
Customer service and repair only
through manufacturer or service
workshops: Please find the nearest
address at:
www.festool.com/Service
Use only original Festool spare parts!
Order No. at:
www.festool.com/Service
Note the following information:
– Keep the ventilation slits on the machine free and
clean to ensure adequate cooling.
– Keep the contacts on the machine, charger and
battery pack clean.
Information on battery packs
– Store in a cool, dry place at a temperature be-
tween 5 °C and 25 °C.
– Protect battery packs from moisture, water and
heat.
– Do not leave flat battery packs in a charger dis-
connected from the mains power supply for lon-
ger than one month. Danger of deep discharge!
– If you intend to store li-ion battery packs for lon-
ger periods without use, you should charge them
to 40 % capacity (approx. 15 min charging time).
Screwing with impact
– WH-CE CENTROTEC tool chuck (see
Chapter CENTROTEC tool chuck [4])
Screwing and drilling without impact
– TI-FX adapter (see Chapter TI-FX adapter
[6])
• DD-AS elbow adapter
• DD-ES eccentric attachment
• DD-DC screwdriver attachment
– BF-TI 13 chuck (see Chapter BF-TI 13
chuck [5])
WARNING
Risk of injury
 Only place the machine on the nut/screw when
switched off.
Battery flat or machine over-
loaded.
– Change the battery.
– Place the machine under reduced
stress.
Machine is overheating.
– You must allow the machine to
cool before using again.
LiIon battery pack is faulty or has
overheated.
– Once the battery pack has cooled,
perform a functional check using
the charger.
WARNING
Risk of injury, electric shock
 Always disconnect the battery pack from the
machine before any maintenance or care work!
 All maintenance and repair work which requires
the motor housing to be opened, must only be
carried out by an authorised service workshop.
EKAT
1
2 3 5
4