Edimax Technology PT-31W - Manual (Page 11)

10
Wireless Setting Wi-Fi Connection using WPS
Method 1: WPS BUTTON
Step 1: Power on the wireless AP and the wireless network camera. Wait for 1
minute for both devices to be up and running.
Step 2: Press the WPS button of the wireless AP. The WPS LED status will
usually flash to indicate that WPS is active – but this is dependent on the
brand of the AP.
Step 3: Press the WPS button of the wireless network camera and wait for 30
seconds.
Step 4: When the network LED of the camera is blinking, a WPS connection
has been successfully established.
Step 5: If you have more than 1 camera, repeat steps 2 - 4 for each additional
camera.