English – Vitek VT-1686 User Manual

Page 10

Advertising
background image

10

ENGLISH

Eliminating malfunctions

Malfunction

Possible causes

Method of elimination

The oven will not
turn on

The power plug is not firmly
connected to the electrical outlet

Remove the power plug from the outlet. Wait 10
seconds and then replace

Problem with power outlet

Try plugging another electrical device into the
outlet to test it

The oven will not heat

The door is not closed firmly

Close the door firmly

When the oven
is operating, the
rotating glass tray
makes strange
noises

The roller ring or the cooking
chamber floor is dirty

Remove the glass tray and roller ring. Wash the
roller ring and the cooking chamber floor

Normal operation

The microwave oven creates static in
television and radio signals.

Static in television and radio signals can occur while the oven
is operating. Similar static is created by small electrical devices
like mixers, vacuum cleaners and electrical fans. This is a normal
occurrence.

The oven light is dim.

If the oven is set to a low power level, the light in the cooking
chamber may also be low. This is a normal occurrence.

Steam collects on the door and
hot air comes out of the ventilation
openings.

During the cooking process, steam is released from the food. Most of
the steam is released through the ventilation openings, but some can
collect on the inside of the door. This is a normal occurrence.

The microwave oven was turned on
without food inside.

Turning on the microwave oven for a short period of time while empty
will not cause any harm. Always make sure there is food in the oven
before starting it.

TECHNICAL CHARACTERISTICS
Operating

Voltage:

220-240

V

~ 50 Hz

Nominal power output in microwave mode:

700 Wt

Operating

frequency:

2450

MHz

Oven

capacity:

17

liters

Glass

tray:

245

mm

diameter

The manufacturer reserves the right to change the device's characteristics without prior notice.

Service life - no less than 5 years.

GUARANTEE

Details regarding guarantee conditions can be obtained from the dealer from whom the appliance was purchased.
The bill of sale or receipt must be produced when making any claim under the terms of this guarantee.

This product conforms to the EMC-Requirements as laid down by the Council Directive 89/336/EEC
and to the Low Voltage Regulation (73/23 EEC)

Vt-1686.indd 10

Vt-1686.indd 10

13.08.2009 14:36:42

13.08.2009 14:36:42

Advertising