VDO Z3 - Manual (Page 34)

25
INSTRUCTION MANUAL
11.3. GETTING STARTED - quick overview
Functions/operation/reset/max values
11.3.0. PERMANENT FUNCTIONS
The following functions are permanently shown in the display:
HEADER
- Actual altitude
- Actual temperature
- Actual ascending gradient in percent ! Not in walk mode !
CENTER BAR
- Heart rate receive icon if the pulse transmitter belt is worn
- Beeper icon if the beeper is switched on
- Stopwatch icon if the timing function is running
- Actual heart rate
- Actual speed: Maximum value 120 km/h or mph (! not in walk mode !)
- Comparison of actual speed to average speed = above, =below
(! not in walk mode !)
- Selected wheel size 1 or 2
FOOTER
- Shows selected information and corresponding value
ALTITUDE FUNCTIONS (button ¥ )
Re-calibrating the air pressure to home altitude. Short-cut press the ¥
button for 4 seconds.
11.3.1. ¬ £ ALTI UP = uphill altitude gain for the actual trip
Display
¥ ALTI UP
Reset: 3 sec. √ TRIP DATA ?RESET?
‚ TRIP DATA ?RESET? <<?RESET?>> flashing
‚ TRIP DATA RESET DONE L
Automatic return to operation mode for TRIP DIST
11.3.2. ¬ DIST UP = uphill distance of the actual trip
Display
¥ DIST UP
Reset: 3 sec. √ TRIP DATA ?RESET?
‚ TRIP DATA ?RESET? <<?RESET?>> flashing
‚ TRIP DATA RESET DONE
This resets all data of the functions marked by L
Automatic return to operation mode for TRIP DIST
Note: The minimum altitude change for the correct distance measure-
ment must be 1 m
11.3.3. ¬ £ TRIP MAX = maximum altitude of the actual trip
Display
¥ TRIP MAX
Reset: 3 sec. √ TRIP DATA ?RESET?
‚ TRIP DATA ?RESET? <<?RESET?>> flashing
‚ TRIP DATA RESET DONE
This resets all data of the functions marked by L
Automatic return to operation mode for TRIP DIST.
11.3.4. ¬ AVG CLIMB = average climb of the actual trip in percent
Display:
¥ „AVG CLIMB
Reset: 3 sec. √ „TRIP DATA ?RESET?
This resets all data of the functions marked by L .
HOME AL
TITUDE