NAD HTR 8 - Manual (Page 10)

To enter Delete Mode, simultaneously
press-and-hold for 3 seconds both the
desired key’s DEVICE SELECTOR key and
the [RTN] key, until the Learn LED turns
green. Press the function key whose com-
mand you wish to delete; the Learn LED
flashes; the number of times indicates
which type of function has become
active - see the table below. Press the
active DEVICE SELECTOR key again to exit
Delete Mode.
Note
You may delete multiple function-key
commands on the same DEVICE
SELECTOR “page”, but to delete from
more than one DEVICE SELECTOR
page you must exit Delete Mode and
then re-enter it on the required page.
Flashes Command Type
1 Default Library Command
2 Copied Library Command
3 Learned Command
LOADING CODE-LIbRARIES
The HTR 8 can store a different library of
default NAD codes for each of its DEVICE
SELECTOR “pages”. If the original default
library does not control your NAD CD
player, BD player, DVD player or other
component, follow the procedure below
to change the code-library.
Begin by ensuring that the component
you wish the HTR 8 to control is plugged
in and powered-up (“ON”, not merely
in standby). To enter the HTR 8’s Library
Mode, simultaneously press-and-hold
for 3 seconds both the desired DEVICE
SELECTOR key and the [A/V PSET] key,
until the Learn LED turns green.
While keeping the HTR 8 pointed toward
the component, enter the first appropri-
ate three-digit code-library number from
the table below and then press [OFF]. If
the component turns off, press [ENTER] to
accept that code-library number and exit
the Library Mode. If the component does
not turn off, enter the next three-digit
code-library number from the table.
When you enter the correct number the
component will turn off; press [ENTER] to
accept that code library number and exit
the Library Mode.
10
ENGLISH
FR
ANÇ
AIS
ESP
AÑOL
IT
ALIANO
DEUT
SCH
NEDERL
ANDS
SVENSK
A
РУ
ССКИЙ
HTR8_eng_OM_v03.indd 10 20/01/2012 1:46am