Hama Switching Console HDMI - Manual (Page 6)

Installation
1. Connect your AV devices (DVD player, satellite receiver, etc.) to the HDMI switching
console inputs. Ensure that your devices are switched off.
2. Connect your display device (monitor, LCD, etc.) to the HDMI switching console output.
3. Connect the 9 V power supply unit to the electrical input of the HDMI switching console.
4. Switch your display device on.
5. Switch your source device on.
6. Switch between the individual devices using the remote control or the select button on the
front side of the HDMI switching console. The yellow LED on the input being received turns
on. All green LEDs also turn on for the inputs with signals.
Troubleshooting
Problem Solution
The HDMI switching console is not
functioning: - Ensure that the 9 V power supply unit is
connected to the HDMI switching console.
No signal is sent to the display device or the
picture quality is very poor: - Ensure that your output device is HDCP-
compatible.
- Your HDMI cable should not exceed a total
length of 5 m.
- Ensure that all cables are correctly
connected.
- Switch all devices off and on again.
The remote control does not work: - Ensure that there are batteries in the
remote control.
Safety Instructions
1. Protect the device from dirt, moisture and overheating and only use in dry rooms.
2. Do not open up the device. If the device becomes damaged, do not continue to use.
Only allow specialists to repair the device.
3. Only use dry, soft cloths for cleaning.
4. Caution: Keep this device, as with all electrical devices, out of the reach of children.
5. Keep away from direct sunlight, radiators and vibrations. Protect from dust.
6. If you do not intend to use the appliance for a long period, disconnect it from power supply.
7. The device is designed for AC 220 ± 240 V / 50 Hz power supplies.
00079091bda.indd Abs1:5 00079091bda.indd Abs1:5 24.04.2007 15:11:03 Uhr 24.04.2007 15:11:03 Uhr