Hama MF110 - Manual (Page 4)

ENGLISH
Step 1: Mount the Wall Plate: Wood Stud installation only
WARNING: Do not overtighten the Lag Bolts. Overtightening the Lag Bolts may damage or weaken them.
Tighten lag Bolts only until Lag Bolt Washer is pulled firmly against the Wall Plate
Wood Stud Mounting: The Wall Plate (A) must be mounted to a wood stud. Use a high quality stud sensor to locate a stud.
It is a good idea to verify where the stud is located with an awl or thin nail. Pre-drill a 2.5” [63.5 mm] deep hole at the desired
height in the stud using a 3/16” drill bit. Make sure the hole is in the center area of the stud. Use this location for the middle
hole in the Wall Plate. Use the Wall Plate as a template to mark the location of the top and bottom holes. Make sure the Wall
Plate is level and drill a 2.5” [63.5 mm] deep hole using the 3/16” drill bit in the marked locations. Attach the Wall Plate to
the wall using three Lag Bolts (P) and three Lag Bolt Washers (Q). Make sure the Wall Plate is oriented so the flat surface
in the center of the plate is against the wall. See Diagram 1 below.
NOTE: The TV will be vertically centered on the Wall Plate once it is mounted.
Diagram 1
(3) Wire Tie Clip - R (2) Safety Bolt - S
(3) Wire Tie - T (1) Allen Key - U
P
A
Q
Drywall cutaway
to show studs.
Stud