Hama VMPL3 - Manual (Page 12)

ENGLISH
Step 9: Hang the Television onto the Wall Plate
CAUTION: Some televisions may require two people to lift. Sanus is not responsible for personal injury or product damage.
CAUTION: The Monitor Brackets must hang on the left and right extension panels of the Wall Plate Assembly, they can not
hang directly on the center plate.
NOTE: For the Low Profile Monitor Bracket, make sure the latch is in the open position.
Hook the Tilting Monitor Brackets (D,E) as shown in Diagram 9A, or the Low Profile Monitor Brackets (F) as shown in Diagram 9B over the
top of the Wall Plate Assembly (A); then, let the bottom of the Monitor Brackets rotate in under the bottom of the Wall Plate Assembly.
Diagram 9A
D,E
Diagram 9B
A
Bottom
Tab
Bottom
Tab
D,E
I
F
A
Bottom
Tab
Latch
Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 USA (100039)
Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com
On the Tilting Monitor Brackets (D,E) tighten Safety Bolts (I) with the Allen Key (J) so that they sit behind the bottom tab on the Wall Plate
Assembly (A) as shown in Diagram 9C or rotate the Latch downward on the Low Profile Monitor Brackets (F) as shown in Diagram 9D.
On Tilting Monitor Brackets (D,E) only, set tension of the knobs and you are free to adjust your new flat panel television without having to
re-tighten the knobs.
Diagram 9C Diagram 9D