GENIUS MaxFire Blaze2 - Manual (Page 3)

English
2
B) For use on PC (for “MaxFire Blaze2”)
Install the Driver:
Put the Driver disk into the CD-ROM of your PC and follow the
directions as they are shown.
Install the game controller:
1. Plug the USB connector of MaxFire Blaze2 into the PC.
2. According to the game request, press the Mode button and choose
the suitable Mode (Digital or Analog Mode).
3. You can now play your game.
Notice: If you don’t use the game controller for a long time, remove the
USB connector from your computer.
C) Turbo/Auto function set up
, , , , L1, L2, R1, R2 can be set up with Turbo/Auto
function. There are three modes: Normal, Turbo and Auto. Normal is
the standard state, Turbo is fast fire state, and Auto is automatic fire
state. Under “NORMAL,” the Turbo LED on the game controller is off.
Turbo set up
1. Select the button you want to be Turbo first.
2. Press the button “once” to set up in fast fire state (Turbo).
3. After establishing the Turbo function, when you press this button,
the green Turbo LED will be lit. You don’t have to press any button;
the green Turbo LED will always be bright.
4. Undo the Turbo function: Press the button you designated to be the
Turbo button “twice”. The Turbo LED will now be off.
Auto set up
1. Push the Turbo button first.
2. Press the button “twice” you want to be in automatic fire state
(Auto)
3. After establishing the Auto function, the green Turbo LED will be lit.
You don’t have to press any button; the green Turbo LED will
always be bright.
4. Remove the Auto function: Press the Turbo button and press the
button “once” that you set up in Auto mode. The green Turbo LED
will be off.
Note: If you want to remove all Turbo/Auto functions at one time, pull
out the connector then plug it again.