STIEBEL ELTRON DHC-E 8-10-12 01.12.2011 - 13.02.2011 - Manual (Page 5)

EN
GL
ISH
qqqĪZ`.
<é<`VHCĪHB +й’ С
.CZ`<<`.HC
BHeC`.C& `+ TT<.C
.CZ`<<`.HC
5. Mounting the appliance
5.1 Application
One appliance can be used for the following applications:
one or multiple hand washing sinks
one kitchen sink
cabins with flow restriction at shower head.
A combination of two appliance can be used for whole apartment
and house applications. Please contact STIEBEL ELTRON for special
installation instructions.
All areas with a ground water temperature likely to exceed 65 °F
(18 °C) year round:
Whole apartment or house
CAUTION Electrocution
Unit must be installed in a vertical position with the
water fittings pointing downward. In this position the
unit is splashproof, so that no water can soak in.
1 2
3
4
5
6
7
26
_0
2
_02
_1
0
8
2
1 2
3
4
5
6
7
26
_0
2
_02
_1
0
8
1
1 Hot valve (left)
2 Cold valve (right)
3 Sink
4 1/2“ main pipe
5 Water supply line for faucet installation
6 Shut-off valve
7 Electrical junction box
5.2 Mounting
f Install appliance as close as possible to the main hot water
draw-off points.
f Install appliance in a frost free area. If frost may occur, re-
move appliance before freezing temperatures set in.
f Leave a minimum of 5“ of clearance on all sides for servicing.
2
6
_0
2_0
2
_1
0
8
3
f Remove plastic cover.
2
6
_0
2_0
2
_0
3
3
1
2
6
_0
2_0
2_
1
0
9
0
f Screw the screws into the wall and hang the appliance.
Screws and plastic wall anchors for mounting on masonry or
wood are provided.
f Secure the screws.
5.3 Water connections

Damage to the appliance and the environment
Excessive heat from soldering on copper pipes near the
DHC may cause damage.