Vitek VT-1761 - Manual (Page 4)

4
ENGLISH
• Do not dismantle the device on your
own, in case of disorder refer to the
nearest authorized service center.
• Clean the device regularly, keep from
scratch appearance on a nebulizer.
• Store the device in places out of reach
of children.
FOR HOME USE ONLY
USE OF HUMIDIFIER
Unpack the device and remove all pack-
ing materials. Inspect the device for
damage. If there is any damage do not
turn on the device.
Note:
- if the humidifier was exposed to
negative temperatures, then be-
fore the first time use it is recom-
mended that you keep it at room
temperature during 30 minutes.
- use the humidifier at indoor tem-
perature from +5 to +40°С, and rel-
ative humidity no less than 80%.
- the temperature of utilized water
should not exceed +40°С.
Before plugging in ensure that the power
network voltage corresponds to the op-
erating voltage of the device.
1. Take the handle (9) and remove water
tank (10) from the body (16).
2. Turn over water tank (10), remove the
top cover (14), by turning it counter-
clockwise. Fill the water tank (10) with
the necessary quantity of water and
secure the top cover (14), by turning it
clockwise.
3. Fix the filled water tank (10) to the body
of the device (16). Wait till the working
compartment is filled with water.
4. Plug in the humidifier.
5. Turn on the humidifier, by turning the
handle (2) clockwise, indicator (5) will
turn green, the spot lighting of regula-
tors (1) and (2) and of water tank (17)
will turn on.
6. Establish steam-out intensity by turn-
ing the handle (2).
7. By a regulator of maintaining relative
indoor humidity (1) «Humidistat», es-
tablish the boundary value of main-
taining indoor humidity from «Min» to
«Max».
«Min» - from 20 % to 30 %;
«Mid» - from 50 % to 60 %;
«Max» - up to 90 %.
Note:
- if humidity in a room is higher than
a set one on the control knob(1),
the moisturizer cannot be turned
on in a steam-out mode .
8. To turn on ionization mode push the
button (3) «ION», in the process the
LED light (4) comes on. To turn off
ionization mode push the button (3)
one more time, the light (4) goes out.
9. On completion of work turn off the de-
vice by setting the control (2) in «OFF»
position, in the process the LED light
(5) goes out, the booster light of the
control knobs (1) and (2) shuts down.
Note:
- (17)the booster light lamp helps
you to estimate the quantity of wa-
ter in the reservoir.
- if the water in the reservoir (10)
is over, the red LED light (5)
«Humidify/Refill» is on, remove the
reservoir and fill it with water.
4
1761.indd 4 1761.indd 4 04.06.2010 10:20:45 04.06.2010 10:20:45